I am writing to report a potential safety and design defect in my vehicle that I have also noticed affecting many other owners of the same make and model. The issue involves the rubber seal at the edge of the windshield, which is supposed to prevent water from entering the engine bay. However, the rubber is not properly secured’it merely sits in place’allowing water to pass underneath it. As a result, water accumulates on the valve cover near the ignition coil, creating a risk of electrical problems, including misfires or potential engine failure. Over time, this could lead to serious mechanical and safety issues. After researching, I have found that many other owners of the same vehicle have experienced this same problem. I believe this issue poses a safety concern and should be investigated further. Please advise on any next steps or potential recalls regarding this matter. Thank you for your time and attention.